- How to make a milling attachment for atlas lathe how to#
- How to make a milling attachment for atlas lathe manual#
So use the quality metal and make it last. A few added accessories and you can do a lot with your Atlas lathe. You want them to last, if you are using scrappy metal you are just practicing. MOST WIDELY USED PHOTOCOPY EQUIPMENT SAVE WASTE PAPER MILL IT ON YOUR LATHE WITH A MILLING ATTACHMENT (COMPUTE WITH VISE) Now you can do light milling. Use a bit of scrap metal and test how good the mill works. lathe for milling out parts in the manifold of a model 4-cylinder gas engine.
Now that you have it all together, put it to the test. This will make a good milling operation for any cutter sizes up to 1/4 diameter. The artical included an address of a small foundry back east that has or had the pattern for the angle base., this was sent to them by the author. For milling operations just tighten the slide adjustment screws on both the compound rest and the cross slide for milling operations. Just a quick note, if you have access to some early to mid 90s Home Shop Machinist mags, they had a good construction series for a milling attachment.
Drill two hole patterns on the other face of the angle plate so the it will mount. Remove the compound rest and using it as a pattern, drill a similar hole pattern in one face.
How to make a milling attachment for atlas lathe how to#
This should give you a three way motion with the drill vise holding the work and the lathe chuck holding the mill end. How to Make a Lathe Milling Attachment Step 1 - Getting Prepared. now bolt it all together and test it out. Using that as a pattern do the same in the drill vise so it will bolt on to the compound rest. Next drill four 10-32 holes int the compound rest on the top.
How to make a milling attachment for atlas lathe manual#
Next you need to remove the tool post bolt out of the compound rest. 618 Atlas MK-I Lathe Manual Originally scanned and posted to the web by gdaniel: Manufacturer: Atlas Press Co. Step 2 - Drilling the Angle Plateĭrill two hole patterns on the other face of the angle plate so the it will mount vertically far or near, with the opening of the vise at the center line of the lathe with the compound rest at the center of its travel. Remove the compound rest and using it as a pattern, drill a similar hole pattern in one face on the angle plate where it will mount there instead of the compound rest. Make sure it will rotate and clamp in any position.
0 kommentar(er)
